An improved On-Surface Radiation Condition for acoustic scattering problems in the high-frequency spectrum

This Note addresses the derivation of an improved On-Surface Radiation Condition for the numerical solution of the exterior Helmholtz equation at high-frequencies. This condition is built as an approximation of the Neumann-to-Dirichlet map by using a local regularization of its principal classical symbol in the gliding zone for modelling the creeping waves. The numerical simulation of this pseudodifferential operator is efficiently realized with a linear cost according to the dimension of the boundary element approximation space using suitable complex Padé approximants. A numerical example is provided. To cite this article: X. Antoine et al., C. R. Acad. Sci. Paris, Ser. I 340 (2005).     

负载型CO3[Fe（CN）6]2及CN^—加氢反应的研究

双金属催化剂是一类重要的多相催化剂。其中d电子在催化活性方面起着重要的作用.本文在Co_3[Fe(CN)_6]_2的工作基础上,进一步研究了该配合物在硅胶、氧化铝、以及氧化镁上的热性质,同时考察了CN~-在Co-Fe体系双端基配位的活化加氢,探讨了载体的影响.     

Low Cost, High Efficiency, Gain Flattened L Band EDFA Using FBGs as C Band Seed Generators

A low cost, coolerless 980nm diode pumped, gain flattened L band EDFA with fast transient control, high pump efficiency and gain clamping effect was realized by using FBGs as C band seed generators.     

机载海洋激光测深系统参量设计与最大探测深度能力分析

详细讨论了机载海洋激光测深系统最大测量深度与相关因子之间的关系，并利用最小可探测信噪比为判据，对机载海洋激光测深系统在白天和晚上工作进行了数值模拟，通过比较最大测量深度与激光脉冲峰值功率、接收视场角、接收口径和光谱接收带宽等关系，确定了系统的主要参量。以确定的参量建立的系统具有白天49m和晚上65m的最大测深能力，可完全满足在沿岸带以及岛礁的测量要求。     

磁电垒结构中自旋极化输运性质的研究

研究了电子隧穿几类磁电垒结构的自旋极化输运性质，导出统一的传输概率公式，揭示了非 均匀磁场的分布与自旋过滤的关系，同时表明采用有效朗德因子较大的半导体材料可以显著 增强磁电垒结构的自旋过滤效果. 关键词： 磁电垒 自旋过滤 自旋电子学 自旋极化     

大口径光束波前采样器(孔栅)的研制

应用平面波角谱理论，分析了采样器对光波场采样和分光的基本原理以及对空间采样频率的选择规则，描述了实际研制的大口径采样器的结构设计，并通过数值方法和高能激光大气传输实验研究了高能激光经采样器前／后的远场光斑分布关系。结果表明：利用光束波前采样器能高保真地实现对高能激光束的分光。     

CNx纳米管的制备、结构观察及低场致电子发射性能研究

采用高温热解法，以乙二胺为前驱液，在沉积有铁催化剂的p型硅（111）基底上制备出了定向生长的CNx纳米管.利用扫描电子显微镜、高分辨率透射电子显微镜和拉曼光谱对CNx纳米管进行了形貌观察和表征.CNx纳米管的高度在20?μm左右，直径在50—100nm之间，具有明显的“竹节状”结构，结晶有序度较差.对CNx纳米管薄膜进行低场致发射性能测试：外加电场为1.4V/μm，观察到20?μA /cm2发射电流，外电场升至2.54V/μm时发射电流达到1.280mA/cm2，在较高外电场下，没有发现电流“饱和”.这比 关键词： CNx纳米管 高温热解 “竹节状”结构 场致发射     

Synthesis and structural characterization of novel,fluorinated poly(phthalazinone ether)s containing perfluorophenylene moieties

The synthesis and structural characterization of a series of novel, fluorinated poly(phthalazinone ether)s containing perfluorophenylene moieties are described. The monomers, 4‐(4′‐hydroxyaryl)phthalazin‐1(2H)‐ones ( 2a – 2d ), were conveniently and efficiently synthesized from phenols and phthalic anhydride in two steps via 2‐(4′‐hydroxybenzoyl)benzoic acids, which were first obtained by the Friedel–Crafts reaction in good yields and with high stereoselectivity and were then converted into 2a – 2d by fusion with hydrazine. All the polymers were prepared by nucleophilic aromatic substitution (S_NAr) polycondensation between the compounds perfluorobiphenyl and 4‐(4′‐hydroxyaryl)phthalazin‐1(2H)‐ones ( 2a ‐ 2d ). The resulting fluorinated polymers were readily soluble in common organic solvents (e.g., CHCl₃, tetrahydrofuran, dimethylformamide, dimethyl sulfoxide, N‐methylpyrrolidone, etc.) at room temperature. Their weight‐average molecular weights and the polydispersities ranged from (7.96–18.25) × 10³ to 1.31–2.71, respectively. Their glass‐transition temperatures varied from 213 to 263 °C. They were all stable up to 390 °C both in air and in argon. The 5% weight‐loss temperatures of these polymers in air and argon ranged from 393–487 to 437–509 °C, respectively. Wide‐angle X‐ray diffraction studies indicated they were all amorphous and could be attributed to the presence of kink nonplanar moiety, phenyl phthalazinone along the polymer backbone. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 925–932, 2004     

Proteins Entrapped in Silica Monoliths Prepared from Glyceroxysilanes

The preparation of discrete polyol based silane precursors derived from glycerol by a simple one-pot process is described. These polyol-based silanes could be hydrolyzed under mild pH conditions and upon gelation resulted in the formation of optically clear, monolithic, mesoporous silica. The hydrolysis and condensation reactions lead to cure rates that are very sensitive to ionic strength, but are almost unaffected by pH in contrast to those of alkoxysilanes derived from primary alcohols such as Si(OEt)₄. Residual glycerol in the silica monolith could be removed by washing, or could be left in the silica to reduce the magnitude of shrinkage during long term storage. The biocompatible glyceroxysilane precursors lead to materials that were able to retain the activity of entrapped enzymes over repeated cycles of use for periods of up to several months.